Sorun Cevaplayalım

İşinizle ilgili öngörüler edinin, gerçek zamanlı bilgilere göre karar alın.

SAP Eğitim ve Sertifika Dönemleri

Uzmanlığınızı ve deneyiminizi SAP çözümleri kullanarak tasdik edin.

Çözüm Ekibi Başvurusu

Kullanıcılara hızlı ve pratik çözümler üreterek görev almak isteyenler.

7.50/7.51 Trial: Configure the transport System

SAP Blog

Kayıtlı Üye
Katılım
22 Ara 2017
Mesajlar
1,035
Tepki puanı
6
How to Install Transport System






The Trial Versions are installed without active transport System.

So User has to call transaction STMS and to configure the transport system by his own.

Transport_A.jpg


You have to click on Icon “Transport Routes”

Then go in Edit-Mode.

Transport_B.jpg


At the beginning the bottom block is empty and the block above contains to Rectangles (NPL, CL5). (Not on the picture any more)



So You mark rectangle NPL and put it into the bottom block.

Then do You the same with rectangle CL5. So they are in the bottom block like in the picture above (without lines).

Then go into “Menu: Edit/”Transport Layer”/Create” and create a new transport layer (e.g. ZNSP).

Go into “Menu: Edit/”Transport Route”/”Add Transport Route”” . The Mouse pointer changes into a pencil.

Click with the pencil on block NPL and don’t finish clicking, till You have made a line to block CL5.

A Popup appears, which let You choose, which transport layer shall be active between these both systems:

Transport_C.jpg


Transport_D-1.jpg


Take the transport layer, You have created before (e.g. ZNSP).

If You want, You can make the same with transport layer SAP, though You shall not use it for Your own developments.

If You save changes, or want to exit Edit-Mode You will be asked, if data shall be saved:

Transport_E.jpg


And if data shall be activated and distributed.

Transport_E2.jpg


You can say Yes at that moment, or make it manually later.



If You have choosen the transport layer, Your transport graphic will look like:

Transport_B-1.jpg


Now double click on system NPL You will get an popup:

Transport_F-1.jpg




Go to register “Standard Transport Layer” and fill in Your created transport layer. This will be used, if You create standard transports.

Transport_G.jpg




Save and acitvate the changes.



If You want, You can test it with a transport export:



Transport_H.jpg


Transport_I.jpg


e.g. example for an exported transport

Transport_J.jpg


You will find the transport in the directories:

/usr/sap/trans/cofiles & /usr/sap/trans/data

Transport_K.jpg


Okumaya devam et...
 
Üst